Baffled by ISA Ethernet

Forum: Networking
Topic: Baffled by ISA Ethernet
started by: PBS

Posted by PBS on April 20 2009,21:17

I have a PI 166Mhz desktop I want to revive with DSL, but since my graphics card takes up my PCI slot, I only have ISA slots remaining. I have a 3com Ethernet III (3C509B_TP0) ISA card installed.

When I boot, DSL detects both an eth0 and an eth1 controller and backgrounds them (even though there is no other on-board ethernet). Attempts to configure either eth0 or eth1 with auto DCHP fails.

When I switch out this card, and install a PCI ethernet controller, only one card (eth0) is detected and the internet is easily accessible.

I have trolled a few forum posts and while the Ethernet III has shown some problems, none mentioned having two ethernet controllers detected.

Is there a simple boot cheatcode that I am missing, or will configuring this ISA card require a more in-depth solution?

Thanks for any assistance...

Posted by PBS on April 22 2009,05:55

I didn't dig deep enough in the posts. Sorry.

If this is your problem, look < here >...

And < here >....

And lock stock and barrel < here >.